USING YOUR ICE MACHINE
Ice maker operaon
• Make certain water pressure is at least 20 psi and no more
than 120 psi and the water is turned on.
• The unit must be installed level for proper ice maker opera-
on.
• The shuto arm wire must be down in its lowest posion for
the ice maker to operate.
• When the freezer secon and ice maker unit has suciently
cooled, the ice maker will harvest ice cubes automacally.
• When the ice bucket is full, the ice maker will automacally
shut o.
• You may manually stop the ice maker by raising the shut o
arm to the locking posion at the up most posion.
Arm down, ice maker
will operate
Arm up, stops operaon
When operaon of the appliance is to be disconnued for any
length of me, the ice cube cavity in the ice maker should be
emped and dried. The water supply and power supply should
also be shut o and the ice bucket should be emped and
cleaned.
If the ice is not used regularly, it will clump together with me.
For best ice results, discard ice in the bin as required and allow
the ice maker to make a new fresh batch of ice.
Figure 9
Cover
pulls o
Water adjustment screw behind cover
on side of housing
Turning on the ice machine
Aer connecng the water supply, and seng your ice machine
in place plug the power cord into the wall receptacle. Then
place the switch located in the grille (see Figure 8) to the “ON”
posion. The temperature control is factory preset, allow the ice
maker to run for 24 hours so the interior temperature will sta-
bilize. If you wish to adjust the interior temperature use a small
bladed screwdriver pushed through the right hand side of the
grille to turn the temperature control sha. Turning it clockwise
will make the unit colder. Turning it counterclockwise will make
it warmer. Turning it counterclockwise unl it stops will shut o
the compressor and fan motor.
Figure 8
“ON/OFF” Rocker
Switch in front grille
Temperature control located
behind right side of air in-
take -exhaust grille.
Should you turn o your control, allow at least ve (5) minutes
before restarng in order to give the motor control me to auto-
macally reset so that it can restart the motor. Electrical power
to your unit is controlled by the “ON/OFF” rocker switch located
in the front grille. (See Figure 8).
Water Fill Adjustment
If the water ll needs to be adjusted, turning the “water adjust-
ment screw” (see Figure 9) clockwise increases the ll amount,
turning it counterclockwise decreases the ll amount. One com-
plete revoluon will aect ll by 40cc.
Do not turn the “water adjustment screw” more than (1) 360°
revoluon in either direcon. Further adjustment than (1) revo-
luon could damage the ice maker module.
8
Comments to this Manuals